Gadgets and props
Here you will find descriptions and pictures of the more commonly used gadgets we use to help her become tied up, released or both and in some cases administer some form of torment.
Clam Cleat - Available from boat suppliers (Holt Allen)
A simple device that allows the rope to pass in one direction only - Can be used to pull arms or legs in one direction such as to a beam or corner of a bed and not come slack.
Winch - Make it yourself
A small low voltage electric winch that can be operated remotely in both directions to pull ropes tight or lower keys etc.
Electo magnet - Comes in many sizes - Used for door access control - Available from security shops
VERY powerful low voltage magnet powered by a plug in type 12 volt power supply.
This one has a timer built in but you can use plug in ones - see bottom of page.
Various Gags
An assortment of gags - The one that is usually questioned is the "medical gag" which is the metal one (top right) in the picture that has a ratchet mechanism to keep your mouth open
Extending bar - Satellite dish actuator
VERY powerful low voltage electric bar that grows in length by about 30 cm (12 Inch) over 2 mins. Operates in both directions and you don’t need to use its full length.
The Mark II whipping / spanking machine - Make it yourself - Diagrams / notes in members area. Or try this company - http://www.orgasmalley.com/som/index.htm
This machine is powered by compressed air which is fully adjustable from very soft to stripe leaving hard. Adjustable timing circuits open and close air valves to the piston and it has two modes of operation.
Auto - Once switched on the machine will administer 'sets' of punishment with rest intervals in between until it is switched off.
Manual - Where the slave presses a button to "ask" for a single stroke to be administered at a time.
Jacking beam - Make it yourself - its just a jack !
A block of wood whose height can be adjusted to fit snug up into the crotch area then be pumped - raising the block of wood higher and is powerful enough to lift the slave into the air (can also have a dildo attached).
End of page
Ice Release - Make it yourself
Its simple ! One 35mm film case, two hooks with metal washers fixed to their ends, fill with water and freeze. Increasing the size of the case will significantly increase the time for the ice to melt and escape!
Please Please play safe. Think ! - Have a backup plan of escape and don’t become a dead statistic !
Controllers - This is the type we use - http://www.homeeasy.eu/
Timers, count down timers, movement sensors, remote controls, power supplies - All these can be plugged into your mains power socket to control, magnets, winches etc.
The bottom left is part of a ‘house automation’ system so a pre-programmed multi event can happen. You can even have things controlled by SMS text - from anywhere in the world ! !


Temperature probe dildo - Make it yourself ?
If you don’t have a lathe then you will have to Google for metal dildo / butt plug making sure it has a hole for the temperature sensor or you will have to drill the hole yourself ! If you look at the picture there is a hole for the sensor next to the threaded part, this goes about half the length of the dildo. And yes metal is best ! The other things you will need are the controller and probe we used a Carel IR32 and probe from Tempatron - Others are available depending on the country you are in and what you want it to do J.
<http://www.tempatron.co.uk/digital_controllers.htm>.